Manufacturing

Hydraulic cylinder design and manufacture is something we do on a regular basis at Perrott Engineering. Cylinder sizes range from very small to quite large in the range of 5meter stroke and 300mm bore diameter.

We have manufactured cylinders from a variety of materials including brass and aluminium for pneumatic service, 316 Stainless and SAF Duplex Stainless steels for marine service and standard steel grades for every day service in all industries.

Winches of all types and sizes up to 50 ton line pull.

Hydraulic manifolds in mild steel, stainless steel, aluminium.

Special valve blocks, adaptors, fittings, pump shafts and general components.

We are often called upon to manufacture parts for customers that are not readily available, have long lead times from the OEM, or are simply priced by the OEM at a cost that is hard to justify. We have the experience, skilled machinists and equipment to manufacture almost anything in this field.

Our Bruker Portable XRF Analyser allows us to determine the composition of all metallic materials in a matter of minutes, our Mitutoyo Hardness tester allows us to determine material hardness, and with these two items we can be sure we have selected the correct material to manufacture your item from.

Specialist hydraulic servicing equipment can be described as cylinder pull down benches, pump and motor test benches and honing machines.

The cylinder pull down benches and honing machine shown in this publication were all designed and manufactured in house by Perrott Engineering and have been designed based on our 45 years in general engineering and 30 plus years specialising in hydraulic servicing.

We don’t just design and manufacture this equip

Manufacturing these screws which are used to achieve level winding of the rope or wire onto a winch drum is not the sort of job we do on a regular basis, but we do get a call to make them probably two or three times a year. Click below for more information on this job.

If you need a small coupling with a splined bore and clamp design, we can make these for you. If you need something a little larger we can also make it for you. These large couplings were designed and manufactured in our Cairns workshop for a project in PNG.

When you need small numbers of gears, splines or rack and pinion units, we can manufacture these for you at an economical level. We are not setup to do complex gears or high speed, high performance ground gears or large quantities, but for those small numbers, we can most likely assist.